This surface can be bare studding, dry wall, or other suitable underlayment material. The dimensions are shown in Figure 1 and the table are from the surfaces where the unit will be attached. The recommended framing and dimensional requirements shown are for a typical application and may vary, depending on on-site requirements. *These measurements are those of the unit for easier installation, add 1/4″ (6 mm) to dimensions A and B.ĭue to individual site variations, exact guidelines for every situation cannot be supplied. ÜAny independent changes made to the unit (or to any options and accessories supplied with the unit) beyond those required for normal installation can void all warranties! (Refer to warranties for further information.)īase size / A B C D 48 x 32 48″ (1219mm) 32” (813mm) 15 ¼” (387mm) 24″ (610mm) 60 x 30 R-L 60″ (1524mm) 30″ (762mm) 14 ¼” (362mm) 8 ½” (216mm) 60 x 32 R-L 60” (1524mm) 32” (813mm) 15 ¼” (387mm) 8 ½” (216mm) Any critical dimensions required for installation should be taken directly from the unit being installed!
ÜAll published unit dimensions are for reference only. ÜAll paperwork packaged with the unit and any associated options or accessories should be saved and presented to the homeowner upon completion of the installation! Ü It is the sole responsibility of the installer to determine, prior to the installation, the requirements necessary for compliance with all codes involving the unit or the installation! In addition, optional items may be shown on the units which may not have been ordered on the unit being installed. NOTE: All drawings in this publication are typical, and may appear different than the actual items being installed. (hereafter “MAAX”) for the proper installation of their product.Ī careful review of these procedures (and any referenced publications) before starting is important in avoiding unnecessary problems resulting in an improper assembly or installation. These guidelines are recommended by Maax Bath Inc.
0 kommentar(er)
